Still iGo neo CX-20, Supplement Instructions

Page: 86 / 112

6
Cleaning
Cleaning the components used for ASSISTANCE mode
Cleaning the components
used for ASSISTANCE mode
Preparing the components used for
ASSISTANCE mode for cleaning
CAUTION
If water penetrates the electrical system, there is a
risk of a short circuit occurring!
– Never clean the components used for
ASSI-
STANCE
mode using devices such as high-pres-
sure cleaners or rotating brushes.
– While cleaning the rest of the truck, avoid clea-
ning the components used for
ASSISTANCE
mode and only clean these components in ac-
cordance with the instructions specified below.
CAUTION
Risk from damage to electrical components when
cleaning!
Only the authorised service centre is permitted
to clean the components used for
ASSISTANCE
mode inside the truck.
– Contact the authorised service centre.
– Park the truck securely.
CAUTION
Risk of component damage!
If you remove the battery male connector when the
key switch is switched on (under load), an arc will be
produced. This can lead to erosion at the contacts,
which considerably shortens their service life.
– Switch off the key switch before the battery male
connector is disconnected.
– Do not disconnect the battery male connector
while the key switch is switched on, except in an
emergency.
– Disconnect the battery male connector.
– Contact the authorised service centre
to arrange for the components used for
ASSISTANCE
mode inside the truck to be
cleaned.
78 50108046085 EN - 08/2017