Still HPT 10 XE, Original Instructions Manual

Page: 53 / 100

Operation
5
Working with loads
Taking up loading units
To make sure that the load is securely sup-
ported, it must be ensured that the fork is
positioned as far as possible under the load.
If possible, the load should rest on the back of
the fork.
The load must not protrude too far over the
fork tips.
Loads are to be picked up and transported
between the fork arms as close as possible to
the centre.
Taking up load
– Only place those pallets into stock that do
not exceed the specified maximum dimen-
sions of 1000 x 1200 mm. Damaged loading
equipment and improperly designed load-
ing units may not be used.
– Attach or secure the load to the load-
carrying equipment so that the load cannot
move or fall.
– Place the loading units into stock so that
the defined aisle width is not reduced by
protruding parts.
6327_003-009
Transporting pallets
As a rule, loading units (e.g. pallets) are to be
transported individually. Transporting several
loading units at a time is only permissible
• when instructed by the supervisor and
• when the technical requirements have been
met.
The operator must ensure proper condition
of the loading unit. Only safely and carefully
positioned loading units may be transported.
50988046052 EN - 10/2018 45