Still GX-Q, Original Instructions Manual

Page: 85 / 100

Optional Equipment
7
Electronic access control
Access control using a "PIN code"
The truck functions can be activated via a
5-digit PIN code. After the button in the op-
erating panel has been actuated, a message
appears on the display (1) and the symbol (3)
flashes. The 5-digit number (2)code must now
be entered via the keypad .
If the PIN code is entered incorrectly 3 times,
an acoustic signal sounds.
To turn off the truck, press the button again for
approximately one second.
NOTE
The 5-digit code can be changed by the
authorised service personnel and therefore
the trucks can be assigned a specific driver.
Two-pedal design
This turret truck can optionally be fitted with
two accelerator pedals, one for each direction.
Driving with pedal (1) - driving in the direction
of the fork.
Driving with pedal (2) - driving in the direction
of the drive.
There is no foot switch. Traction power and the
hydraulic functions are only enabled when the
seat is under load (seat switch). The direction
of motion is also not required.
Changing direction with Two-pedal
design
5220 804 2501 [EN] 79