Still GX-Q, Original Instructions Manual

Page: 40 / 100

4
Operation
Commissioning
Hooking on the horizontal lift mast
If the lift mast has to be crane-loaded in a
horizontal position, suitable shackles should
be used in the indicated bores at the top end
of the mast. At the lower end, a textile strap
can be wound around the cross web in the
beam support of the sideshift. If necessary,
the individual lift mast parts can be lashed to
each other to prevent them from separating
unintentionally and thus shifting the centre of
gravity.
Loading
To secure the truck to a loading area for
transport, a total of 8 wooden wedges and
suitable tension belts are to be used. Position
two of the wooden blocks each at the front and
rear of the truck, and the others in pairs on the
right and left of the truck. The tension belts are
to be guided over the battery compartment and
around the posts of the lift mast to make sure
the truck is firmly on the ground. For trucks
with high lift masts, additional tension belts are
to be attached on the side to the lift mast posts
at the height of the overhead guard, and are to
be anchored to the ground.
Installing the battery
WARNING
Risk of corrosion
The electrolyte (battery acid) is poisonous and
causes corrosion. When handling battery acid, the
prescribed safety measures must be adhered to.
34 5220 804 2501 [EN]