Still FXV 14, Original Instructions Manual

Page: 72 / 174

Parking brake
Using the parking brake
Different conditions can cause the truck to
stop and apply or lock the parking brake.
When the truck is in motion, it decelerates un-
til it comes to a stop and then the brake is ap-
plied or locked (2).
The brake is applied (indicator flashing) (2) if
one of the following conditions is met:
●
The operator releases the traction control
●
The operator presses the brake pedal
●
The operator releases the operator pres-
ence pedal
●
In forward travel, the forklift operator leaves
the seat for more than 1 second while keep-
ing the presence pedal pressed down
The brake is locked (indicator permanently on)
(2) if one of the following conditions is met:
●
The forklift operator presses the parking
brake button (1)
●
The forklift operator leaves the seat and re-
leases the presence pedal and the traction
controller at the same time
When the truck is stopped and the brake is
applied (indicator flashing) (2), the brake
switches automatically to locked status (indi-
cator permanently on) (2) if one of the follow-
ing conditions is met:
●
The operator leaves the seat
●
The presence pedal is released
●
After a period of time has elapsed (3 s by
default)
NOTE
After a power failure or an emergency stop
(emergency stop button), the truck still restarts
with a brake in the locked status (indicator
permanently on) (2).

Use
4
Driving
62 11748011651 EN - 02/2021 - 06