Still FXD 20, Original Instructions Manual

Page: 53 / 162

Adjusting the floor
The floor is fitted with a pressure-based height
adjustment system.
To adjust the floor height, proceed as follows:
–
Sit on the seat.
–
Press the floor unlocking button (2) and
hold it down for the duration of the opera-
tion.
–
Exert pressure on the floor (3) by pushing it
with your right leg to obtain a good driving
position.
–
Release the button.
NOTE
Adjusting the floor is not possible when the
truck is in cold store. The adjustment cylinder
does not work at low temperatures.
Seat heater option
The driver's seat may be equipped with the
seat heater option.
The heater turns on when the operator's pres-
ence on the seat is detected.
To activate the heater, proceed as follows:
–
Sit on the seat
–
Adjust the weight of the operator
–
Put the truck into service
–
Press the LED button (1) to activate the
heating
The LED button (1) illuminates to indicate that
the heater is in operation.
NOTE
When the driver gets up or leaves the seat,
the heating stops in order to conserve battery
power.
No visual information is shown on the display.
–
Check whether the LED button (1) is on


Use
4
Driver's compartment settings
43 11648011751 EN - 02/2021 - 06