Still FM-X EW Series, Original Instructions Manual

Page: 205 / 360

Operation
4
Lift height preselector/easy Target (variant)
NOTE
Before a new height can be set via the display,
a reference drive must be carried out. Heights
that are below the reference height can be
saved by entering them manually. However,
if such a level is selected, automatic operation
cannot be used.
Only preset heights can be changed via
the display. No other truck-specific height
preselection parameters can be changed.
This can only be done using the service
software.
The following parameters, among others, can
be changed using the service software:
• Pallet free lift height
• Pallet free lowering height
• Accuracy and speed of pallet free lift and
pallet free lowering
• Accuracy and speed of homing
Performing a teach-in
The teach-in for height preselection is carried
out using the display and the enter keys for the
display and operating unit.
The values for the programmable lift heights
must be entered via the enter keys on the
numeric keypad. It is not possible to move the
fork to a lift height and transfer this value to the
height preselection system.
50988078001 EN - 10/2018 193