Still FM-X EW Series, Original Instructions Manual

Page: 198 / 360

4
Operation
Lift height preselector/easy Target (variant)
If the load support is not in free lift, a reference
drive is required. In this process, the load sup-
port is lowered until it is below the reference
switch, then raised again.
Reference height
The reference height is the distance from the
upper edge of the load support to the floor
when the reference switch is tripped. The
reference height differs according to the lift
mast height and can be set using the service
software.
The set value also determines which basic
height is shown in the display if the free lift has
ended and the main lift is beginning.
AUTO MODE function
For height preselection, there are four con-
figurations available for selection in the ser-
vice software. The configuration can only be
changed by the authorised service centre.
"Truck options 1" page:
• AUTO MODE height preselection "Basic
position"
• AUTO MODE height preselection "Any
position"
• AUTO MODE height preselection "Without
fork cycle"
• AUTO MODE height preselection "Start
only with fork below target height"
AUTO MODE height preselection "Basic
position"
In the "Basic position" configuration, the
assistant also specifies, in addition to the
height preselection, the respective position of
the reach carriage.
Once the area and level have been entered,
the place into/remove from stock function must
be selected to activate height preselection.
• If the reach carriage is not in the basic
position, the assistant specifies "retract
186 50988078001 EN - 10/2018