Still FM-X EW Series, Original Instructions Manual

Page: 193 / 360

Operation
4
Battery change frame (variant)
charged battery can also be carried on the
second roller channel.
1
Adjusting the transfer height
– Use an external spirit level or straight-edge
to check the height of the battery rack and
that it is level. This is done by matching
the upper edge of the roller channel on the
battery rack to the roller channel on the
truck.
– If necessary, loosen the lock nut (1) on the
levelling foot to be adjusted.
– Adjust the levelling foot by turning it clock-
wise or anti-clockwise. For this purpose, lift
the rack slightly to facilitate adjustment.
– Tighten the lock nut.
– On stationary systems, the levelling feet
must be bolted to the floor once any ad-
justments have been made Refer to the
information in the original operating instruc-
tions from the manufacturer of the change
frame.
1
Locking the battery change frame
DANGER
Risk of physical injury
Before unlocking the swing bolt, check that the
battery rack is on a horizontal surface and that the
floor has a sufficient load capacity. This is the only
way to ensure that the battery does not move in an
uncontrolled manner and trap or crush parts of the
operator's body.
When batteries are transported on battery
racks, they must be secured with a swing bolt.
Grasp the swing bolt by the projecting knob
(1) and swing the bolt to open or close it. To
make it easier to release the swing bolt, push
the battery back slightly on the roller.
50988078001 EN - 10/2018 181