Still FM-X EW Series, Original Instructions Manual

Page: 167 / 360

Operation
4
Attachments
Load capacity with attachment
The permissible load capacity of the attach-
ment and the allowable load (load capacity
and load moment) of the truck must not be ex-
ceeded by the combination of attachment and
payload. The specifications of the manufac-
turer and supplier of the attachment must be
complied with.
– Observe the residual load capacity rating
plate, see the chapter entitled "Taking up a
load using attachments".
7090_900-001
Releasing the pressure from the
auxiliary hydraulics
Attachments must only be fitted by competent
persons in accordance with the information
provided by the manufacturer and supplier
of the attachments. After each installation,
the attachment must be checked for correct
function prior to initial commissioning.
Prior to assembling attachments, the pressure
must be released from the plug connectors
(arrows).
2 1
Performing the truck function "Release
the pressure from the hydraulics"
– Fully lower the lift mast and fork carriage.
In doing so, wait until the lift mast, which is
braked by the mast slowdown at the end of
the lowering process, is fully lowered.
– Rest the fork tips fully on the ground by
tilting.
– Switch off the key switch.
– Wait for five seconds, then switch on the
key switch.
– Using your left hand, press and hold the
ESC button (2) immediately after switching
on the truck.
– If present, operate the foot switch.
50988078001 EN - 10/2018 155