Still FM-X EW Series, Original Instructions Manual

Page: 201 / 360

Operation
4
Lift height preselector/easy Target (variant)
Operating the lift height preselector
1
2 5 6
4 3
General
WARNING
If the load support is tilted there is a risk of collision
with the pallet or racking!
The load support must always be in the "0° position"
during placement into stock/removal from stock
operations!
NOTE
If height preselection is active, only the arrow
symbols for movements that are still possible
will light up on the function symbols in the
assistant (1). The required movement is
identified in each case by a corresponding
flashing arrow symbol. Function symbols
without arrow symbols mean that the function
is blocked. If the load support is above the
free lift height, a reference drive must be
performed after switching on to activate the
height display.
The initial position for this description is a re-
tracted reach carriage (shifting measurement
system reports DS end position) and a lift mast
in free lift. Other combinations are also possi-
ble. However, they lead to different displays
on the assistant (1). The assistant specifies
the function that must be carried out. The fol-
lowing description is intended as an example.
When the truck has been switched ON, area
"A" (2) is automatically selected. The area can
be changed by pressing the button (3). If "H"
is reached, "A" is repeated. This enables area
preselection. A level can be selected (1-20)
by entering a digit using the alphanumeric
keypad (4). The complete selection (level and
area) is shown in the display (5). The stored
target height is displayed under (6).
NOTE
During free lift, the difference between the re-
ference height and the target height is shown
on the display as the "lift height remaining un-
til target (target difference)" (6). The display
does not show the difference between the cur-
rent lift height and target height until after the
50988078001 EN - 10/2018 189