Still EXU-H-18, Original Instructions Manual, Page: 83 / 142

Gel or Lead batteries: Adjusting the
on-board charger
●
When the truck is delivered with its battery,
the charger settings are adjusted in the fac-
tory.
●
The adjustment depends on the selected
battery.
Charging curve selector
The curve is selected using the selector loca-
ted on the front face of the charger.
The curve selector is protected by a cap.
The four thin lines indicate neutral positions.
The charger does not flow and the two diodes
flash simultaneously to indicate that no curve
has been selected.
The four thick lines indicate the four charging
curves:
●
open lead-acid battery with a capacity be-
low 210 Ah
●
open lead-acid battery with a capacity
greater than 210 Ah
●
gel battery with a capacity below 210 Ah
●
gel battery with a capacity greater than
210 Ah
If the battery is changed during the service life
of the truck, it is essential to ensure that the
charger settings correspond to the new battery
type. Any modification to the settings must be
carried out by a qualified technician.
Changing the battery
Maintain a safe distance for battery removal to
avoid damaging the truck.

Use
4
Handling the battery
73 1152 801 15 17 EN - 02/2021 - 14