Still EXU-H-18, Original Instructions Manual, Page: 42 / 142

Description
The pallet trucks EXU-H18 and EXU-H20 are
made up of a high lift (fork arm) and a low lift
(load arm).
The fork arms are used to level the pallet thus
limiting incorrect posture during load handling.
The pallet can reach a height of 800 mm
above the ground.
EXU-H capacity
EXU-H18: 1800 kg maximum on the load
arms and 800 kg maximum on the fork arms
EXU-H20: 2000 kg maximum on the load
arms and 800 kg on the fork arms
EXU-H20*: 2000 kg on the load arms and 800
kg on the fork arms.
*S: Folding platform
Applications
- pallet truck
- rolling lift table/levelling table (height 800
mm)
- order picking
- double stacking (occasional for this type of
truck), it is possible to load an empty pallet on
the load arms
Driving
Drive is provided by a 1.2 kW asynchronous
traction motor.
The motor unit is driven by the truck controller,
which incorporates the transistor speed con-
troller.
The power supply to the traction motor is con-
trolled by an electronic controller with micro-
processor, which provides complete control of
speed, acceleration and braking.
Power is supplied by a 24 volt lead-acid bat-
tery.
Two types of battery removal are available
●
Vertical removal (2Pzs BS) on EXU-H18
and (2Pzs DIN) on EXU-H20
●
Side removal (2Pzs DIN) available as an
option on EXU-H20 and EXU-H20S.
Steering
A long, robust, ergonomic tiller allows the op-
erator to direct the drive/steering wheel effort-
lessly.
For safety reasons a gas spring automatically
returns the tiller to the upper position when it
is released.
The speed of the truck is limited to 6 km/h in
both directions of travel (key in the Hare posi-
tion).
The speed of the truck is limited to 4 km/h in
both directions of travel (key in the Tortoise
position).
Lifting system
The cylinder activates the lift shaft, which
transmits the movement to the push rods.
These activate the wheel clevises, resulting in
the load arms lifting.
All the joint pins are treated for anti-wear and
anti-corrosion properties. The joint rings are
self-lubricating.
Pump motor power:
●
EXU-H18, EXU-H20 and EXU-H20S: 1.2
kW
Braking system
●
counter-current, upon accelerator release
●
counter-current by reversing the drive direc-
tion
●
counter-current, controlled by the anti-crush
safety button
●
electromagnetic safety device, controlled by
the emergency stop handle
Use
4
Description
32 1152 801 15 17 EN - 02/2021 - 14