Emissions
Noise emission values
Calculated during the test cycle performed in
accordance with standard EN12053.
Acoustic pressure level in the driver's compartment
EXUH 18, EXUH 20, EXUH 20S
L
PAZ
=
59 dB (A)
Uncertainty
K
PA
±
2.5 dB (A)
NOTE
Lower or higher noise values may occur when
using industrial trucks, e.g. due to the mode of
operation, environmental factors and other
sources of noise.
Vibration values for upper limbs
These values were determined following tests
using trucks with standard equipment accord-
ing to the datasheet (driving over test course
with humps).
Specified characteristics for upper limb vi-
brations
Vibration values
< 2.5 m/s
2
NOTE
The vibration characteristics for bodily vibra-
tions cannot be used to determine the actual
vibration load level during operation. This de-
pends on the operating conditions (state of
ground, mode of operation etc.) and should
therefore be determined on site, if applicable.
It is mandatory to specify the hand-arm vibra-
tions even where the values do not indicate
any hazard, as in this case.
Safety
2
Emissions
16
1152 801 15 17 EN - 02/2021 - 14
Summary of Contents for EXU-H-18
