Still EXP 14, Original Instructions Manual

Page: 30 / 144

3
Overview
Technical description
Technical description
General characteristics
The trucks described in this manual EXV 14,
EXV 16, EXV 20, EXV 14i, EXV 16i and EXV
20i, EXV 14-SF, EXV 16-SF, EXV 20-SF, EXV
14i-SF, EXV 16i-SF, EXV 20i-SF, EXP 14,
EXP 16, EXP 20 are designed to move and
stack pallets inside shops, warehouses and
factories.
Versions
• For the basic version (EXV and EXP)
the operator always guides the truck in
pedestrian mode (operated "from the
ground)" as there is no platform.
• The version"SF" is provided with a platform
for driving on board the truck. The operator
can use the truck both in pedestrian mode
(driving "on the ground") and in the mode
of "driving on board" by getting up on to the
appropriate operator’s platform.
• The version"i" is prepared for lifting and
lowering the spokes. It is available for both
the basic version of the truck and for the
version ."SF".
Lift
Nominal load:
• 1400 kg (EXV 14, EXV 14i, EXV 14-SF,
EXV 14i-SF, EXP 14)
• 1600 kg (EXV 16, EXV 16i, EXV 16-SF,
EXV 16i-SF, EXP 16)
• 2000 kg (EXV 20, EXV 20i, EXV 20-SF,
EXV 20i-SF, EXP 20)
Pump unit
• Power rating 3.2 kW
Different types of lift mast:
• Telescopic "post": two-section telescopic
post without free lifting and two side cylin-
ders
• "NiHo" post: two-section telescopic post
with free lifting, lateral chains and two lateral
cylinders plus a central cylinder
• Triplex "post" : three-section telescopic
post with free lifting, lateral chains and two
lateral cylinders plus a central cylinder
Driving
The 185-W electric steering motor operates
the drive wheel using a reduction gear unit.
2.3 kW drive motor
On EXV, EXVi and EXP versions the operator
guides the truck from the ground. A long
ergonomic helm together with electric steering
allows the operator to drive the truck without
effort.
In versions EXV-SF the operator can drive the
truck on land or on board. A strong ergonomic
helm together with electric steering allows the
operator to drive the truck without effort.
The tiller is used to activate the following
controls:
• Steering
• Drive control throttle
• Horn
• Fork lifting and lowering buttons
• Anti-crush safety button
• Truck braking when the tiller reaches the
upper end position and lower end position
(service brake)
• Buttons for raising and lowering spokes
(only for versions"i")
For safety reasons, the helm automatically
returns to its initial position when released.
Braking system
Regenerative braking
24 45758043402 [EN]