Still EXH 25, Original Instructions Manual, Page: 71 / 130

–
Slowly withdraw the load in a straight line.
Transporting a load
Observe the following recommendations:
●
Drive forwards for optimum visibility
●
Travel up or down slopes with the load up-
hill. Do not travel across the slope or make
a U-turn
●
Reverse travel is used for setting down the
load. Adjust your speed
●
Do not drive with an unstable load
●
If visibility is poor, let someone guide you
●
Raise the forks slightly in order to pass ob-
stacles
●
Be careful of low passageways, low door-
ways, scaffolding, pipes etc.
●
Check that the width of the load is not
greater than the width of the aisle
Setting a load down on the ground
Proceed as follows:
–
Drive the truck to the required location.
–
Carefully move the load into the unloading
zone.
–
Lower the load until the load arms are free.
–
Withdraw the truck in a straight line.
–
Raise the load arms again by a few centi-
metres.
CAUTION
Risk of accident
Before you set down the load, ensure that no one is
around the truck or the load.
Before leaving the truck
NOTE
Always stop the truck on level ground away
from traffic routes.
Proceed as follows:
–
Lower the load arms to the lowered posi-
tion.

Use
4
Transporting loads
63 11538011551 EN - 02/2021 - 08