Still EXD-S 20, Original Instructions Manual

Page: 76 / 144

Picking up a load from the ground
–
Use the initial lift to raise a load of up to
2000 kg several centimetres from the
ground.
Transporting a load
DANGER
Risk of accident
There must be no one under or near the truck when
the load is in the raised position.
DANGER
Risk of falling
Never transport a load with the forks in the raised po-
sition as the truck may become unstable.
Observe the following recommendations:
●
Drive forwards for optimum visibility
●
Travel up or down slopes with the load up-
hill. Do not travel across the slope or make
a U-turn
●
Reverse travel is used for setting down the
load. Adjust your speed, as the position of
the forklift operator is now less comfortable
●
Do not drive with an unstable load
●
If visibility is poor, let someone guide you
●
Raise the forks slightly in order to pass ob-
stacles
●
Be careful of low passageways, low door-
ways, scaffolding, pipes etc.
●
Check that the width of the load is not
greater than the width of the aisle
Setting a load down on the ground
Proceed as follows:
–
Drive the truck to the required location.
–
Carefully move the load into the unloading
zone.
–
Lower the load until the forks are free.
–
Withdraw the truck in a straight line.
–
Raise the forks a few centimetres.

Use
4
Transporting loads
66 11638011751 EN - 02/2021 - 03