Still EXD-S 20, Original Instructions Manual

Page: 26 / 144

Emissions
Noise emission values
Calculated during the test cycle performed in
accordance with standard EN 12053.
Acoustic pressure level in the driver's compartment
Truck
L
PAZ
= 62 dB (A)
Uncertainty K
PA
± 2.5 dB (A)
NOTE
Lower or higher noise values may occur when
using industrial trucks, e.g. due to the mode of
operation, environmental factors and other
sources of noise.
Vibration characteristics for vibrations to which the body is exposed
The values were determined according to EN
13059 using trucks with standard equipment
according to the datasheet (driving over test
course with humps).
Specified characteristics for upper limb vi-
brations
Vibration characteristics
< 2.5 m/s
2
NOTE
The vibration characteristics for bodily vibra-
tions cannot be used to determine the actual
load level of vibrations during operation. This
depends on the operating conditions (state of
ground, mode of operation etc.) and should
therefore be determined on site, where appro-
priate. It is mandatory to specify the hand-arm
vibrations even where the values do not indi-
cate any hazard, as in this case.
Safety
2
Emissions
16 11638011751 EN - 02/2021 - 03