Raising/lowering the mast
Lifting the mast:
–
Press button (2).
The forks are raised.
Lowering the mast:
–
Press button (1).
The forks are lowered.
When the lifting control (1) is released, the
forks stabilise at the required height.
NOTE
A groove (3) is present on each side of the
button. This helps you to feel the button and to
identify it even if there is not much light.
Initial Lift
Lifting the load arms:
–
Press the button (4).
The load arms are raised.
Lowering the load arms:
–
Press the button (5).
The load arms are lowered.
CAUTION
Risk of the load swinging and loss of stability
Do not drive with a load in the raised position with-
out load on the load arms. The high load must be
lowered as close as possible to the load in the low
position. The operator must lower the forks again be-
fore moving the truck.
Use
4
Transporting loads
67
11638011551 EN - 02/2021 - 06
Summary of Contents for EXD 20
