Still ECU-SF-20, Original Instructions Manual, Page: 65 / 92

Maintenance
5
Supply Table
Supply Table
Quantity
Element to be
supplied
dm
3
kg
Lubricants
International lubricant
specifications
Hydraulic
system
0.5
-
IDRAULICAR AP31
TUTELA GI/M ( )
MIL-H-24459-DIN 51524/51525
ISO-VG-32
ATF Type A - Suffix A ( )
Reducer 1.2
-
TUTELA MATRIX
TUTELA MATRIX ( )
SAE 75W/85– API GL4– ALLISON
C4– ZF TE ML06 4B&C) LEVVEL
SAE 75W/85– API GL4– ALLI-
SON C4– ZF TE ML06 4B&C)
LEVVEL ( )
General
lubrication
-
1.5
TUTELA MP02
TUTELA JOTA 1 ( )
Lithium soap grease
N.L.G.I.2, QFK 587/GR consistency
NOTE
( ) = Cold store version
Resolution of Operating
Defects
The operating defects which can occur during
truck use are indicated in this section, with
relative causes and solutions. If the defects
should persist even after having carried
out all of the checks indicated, contact the
manufacturer’s authorised service network.
Defect: THE TRUCK DOES NOT START OR MOVE.
POSSIBLE CAUSES
SOLUTIONS
Battery socket not connected or connected
incorrectly.
Check the battery socket and, if necessary,
connect it correctly.
The emergency stop button is pressed.
Release the emergency stop button and then
turn the truck off and on again in sequence
using the start/stop key.
Low battery charge.
Check the battery charge level and, if neces-
sary, charge it.
Incorrect command sequence when switching
on the truck.
Repeat the sequence of commands correctly.
The drive control throttle is not turned.
Turn the drive control throttle in the desired
direction of travel.
The key ignition switch is set to position "0"
(truck off).
Turn the switch to "I" (truck on).
45378043402 [EN] 59