Still CX-T-40, Original Instructions Manual

Page: 104 / 146

5
Operation
Decommissioning
Servicing the battery
Observe the applicable national regulations
for the installation and operation of battery
charging units. Obey the operating instruc-
tions for the charging unit or charger and the
battery. The following safety regulations must
be observed when servicing, charging and
replacing batteries:
Fire precautions
Smoking and naked flames are prohibited
in the vicinity of batteries. No inflammable
materials or spark-producing materials may
be located within at least 2 metres of the truck
to be charged and the charger. The room must
be well ventilated. Keep fire extinguishers
ready.
Safe parking
When the battery is being worked on, the truck
must be properly parked and it may only be
started when the battery cover is closed and
the battery plug connected.
Battery servicing
Keep the battery cell lid dry and clean. Neu-
tralize spilled electrolyte immediately. Termi-
nals and cable lugs should be clean, slightly
greased and secure.
Battery charging
Switch off the truck and charger before
removing the plug from the socket. During
charging, keep the surface of the battery
cells exposed in order to provide sufficient
ventilation. Do not place any metallic objects
on the batteries. While charging the battery
keep battery cover open.
Decommissioning
1044_001-006
1
Leaving the truck unattended
WARNING
Do not park the truck on gradients. In special cases
secure the truck with chocks.
– Disconnect the battery connector (1).
NOTE
If you leave the pallet truck without disconnec-
ting the battery connector, the control is shut
off automatically after approx. 15 minutes.
The truck can only be operated again after
reentering the driver code.
96 51048070007 [EN]