Still 6219, Original Instructions Manual

Page: 481 / 540

Category of the truck Maximum permissi-
ble damaged area
IIB + H
2
20 cm
2
IIB + C
2
H
2
IIB + H
2
+ C
2
H
2
–
Please contact your authorised service cen-
tre for replacement or advice if you have
any questions.
Checking the antistatic paint layer
DANGER
Risk of explosion due to static charge!
Depending on the version, non-conduc-
tive parts (plastic parts) on the truck
must be painted using a special antistat-
ic paint. This paint prevents the parts
from building up an electrostatic charge.
Otherwise, static discharge may occur,
resulting in explosions in the surrounding
atmosphere in potentially explosive
areas.
–
Have any damage repaired by your
authorised service centre.
–
Check the paint layer on the plastic parts for
damage and abrasion.
The antistatic paint is applied to the following
plastic parts:
●
Panelling
●
Consoles
●
Steering column panelling
●
Document holders
●
Compartments
●
The protected areas are identified with the
decal information "ELECTRICALLY CON-
DUCTIVE".
●
Non-coated areas are labelled as follows:
"Non-conductive parts - risk of electrostatic
charge - only clean using a damp cloth"
●
The surface resistance must be less than or
equal to 1 GΩ (10
9
Ω) at a test voltage of
500 V
●
Any damage to the paint layer must not ex-
ceed a specified surface area.
Maintenance
5
Preserving operational readiness
465 56368011531 EN - 01/2021 - 05