Still 6219, Original Instructions Manual

Page: 374 / 540

WARNING
Risk of component damage if the tiller in the tow cou-
pling is tilted!
The tiller should be kept as horizontal as possible
when towing. This ensures that the rotation range is
sufficient at the top and bottom. The authorised serv-
ice centre can adjust the assembly height for the tow
coupling to the tiller height if necessary.
–
Make sure that the tiller is level.
–
To change the coupling height, contact the author-
ised service centre.
NOTE
When manoeuvring in restricted areas, take
into account the projection of the coupling.
Coupling the trailer
NOTE
Tow coupling RO*244 is intended for a tow-
bar eye in accordance with DIN 74054 (bore
diameter 40 mm) or DIN 8454 (bore diameter
35 mm).
–
Take measures to prevent the trailer from
rolling away, e.g. using wedges.
–
Adjust the tow bar eye of the tiller so that it
is at the centre of the towing jaws.
–
Push the hand lever (2) upwards until it
snaps into place.
The tow coupling is opened.
CAUTION
When being coupled, the tow-bar eye must engage
in the middle of the coupling jaw. Failure to follow
these instructions could result in damage to the cou-
pling jaw or to the tow-bar eye!
–
Ensure that the tow-bar eye enters the coupling
jaw centrally.
–
Move the truck back slowly until the tow bar
eye is inserted centrally into the coupling
jaw of the tow coupling and the coupling pin
engages.

Operation
4
Trailer operation
358 56368011531 EN - 01/2021 - 05