Still 6219, Original Instructions Manual

Page: 110 / 540

Checks and tasks before daily use
Visual inspections and function checking
WARNING
Risk of injury from falling off the truck!
When climbing onto the truck, there is a
risk of getting stuck or slipping and fall-
ing. Use suitable equipment to reach
higher points on the truck.
–
Use only the steps provided for this
purpose to climb onto the truck.
–
Use equipment such as stepladders
or platforms to reach inaccessible
areas.
Damage to the truck or the attachment (var-
iant), non-functional switches or safety sys-
tems and modification of predefined set values
can lead to unpredictable and dangerous sit-
uations. To ensure that the truck is operated
safely, the visual inspections and function
checking must be carried out before daily use.
The components that must be checked and
their check points are listed in the following ta-
ble. If damage or other defects are identified
on the truck or the attachment (variant) during
the following inspections, the truck must not
be used until it has been properly repaired.
Damage or other defects must be reported to
the supervisor or the responsible fleet manag-
er immediately so that repairs by the author-
ised service centre can be arranged.
Ensure that the truck is safe for operation each day before it is used:
Component Course of action
Fork arms, general lifting accessories
Perform a visual inspection to check for deformation
and wear (e.g. to check if they are bent, broken or
feature significant wear).
Check the condition and function of the safety devi-
ces (1) to prevent lifting and shifting.
Check that fork arms and, where applicable, fork
extensions with a special cladding specifically for
explosion protection are fitted.
The minimum thickness of the cladding must be at
least 1 mm at every point.
See the section entitled "Checking the fork arms".
Roller tracks (2) Make sure that there is a film of grease.
Fork arms and roller tracks

Operation
4
Checks and tasks before daily use
94 56368011531 EN - 01/2021 - 05