1 Introduction
ASTODIA Instructions for Use
13
1.7 Liability
The manufacturer shall be liable for the safety, reliability, and performance of the
equipment only when all operating, servicing, and calibration procedures have
been carried out by trained and qualified persons according to the procedures
published by the manufacturer; when only original spare parts have been used to
replace components as needed; when the assembly and completion of repairs
have been carried out only by authorised persons or an authorised service centre;
when the electrical installations satisfy the locally applicable regulations and the
IEC/EN requirements; and when the equipment is used for its intended purpose
and at a suitable location in accordance with the instructions for use.
On request, STIHLER ELECTRONIC GmbH will provide service instructions that
will allow properly trained and qualified persons to repair the parts of the equip-
ment that the manufacturer has designated as reparable.
The provision of technical documents or spare parts is not an authorisation from
the manufacturer to open or repair the equipment.
1.8 Disposal of the equipment
Electrical devices are recoverable waste and should not be disposed of in domes-
tic waste at the end of their service life. Please follow the local rules for the dis-
posal of used products, or send the cleaned and disinfected equipment with a
corresponding note to STIHLER ELECTRONIC GmbH or your closest sales point.
This will ensure the most cost efficient and proper disposal of your old equipment.
Follow the national regulations on the disposal of medical products.
Summary of Contents for ASTODIA DIA100
Page 27: ......
