Stihl RME 235, Instruction Manual, Page: 16 / 196

0478 121 9804 A - EN
14
new component, ensure that the new
component is provided with the same
stickers.
Only perform work on the cutting unit when
wearing thick work gloves and exercising
extreme care.
Ensure that all nuts, pins and screws (in
particular the blade fastening screw) are
securely tightened so that the machine is
in a safe operating condition.
Check the complete machine and the
grass catcher box for wear or damage on
a regular basis, particularly before
extended periods when the machine is not
in use (e.g. over winter). For safety
reasons, worn or damaged parts must be
replaced immediately to ensure that the
machine is always in a safe operating
condition.
Components or guards that are removed
for maintenance operations must be
properly reinstalled immediately.
Regularly check that the mowing blade is
securely fastened and is not damaged or
worn.
4.8 Storage for prolonged periods
without operation
Store the cooled machine in a dry and
locked place.
Ensure that the machine is protected from
unauthorised use (e.g. by children).
Thoroughly clean the machine before
storage (e.g. winter break).
Store the machine in good operational
condition.
4.9 Disposal
Ensure that old machines are properly
disposed of. Render the machine
unusable prior to disposal. In order to
prevent accidents, ensure that you remove
the power supply cable or the electric
cable to the motor.
Risk of injury due to the cutting tool!
Always store an old machine in a safe
place prior to scrapping. Ensure that the
machine and the cutting tool are kept out
of the reach of children.
6. 1 Assembling lawn mower
5. Description of symbols
Caution!
Read the instruction man-
ual before initial use.
Risk of injury!
Keep other persons out of
the danger area.
Risk of injury!
Beware of the sharp mowing
blade. The mowing blade
runs on for several seconds
after switching off
(motor/blade brake). Before
performing any work on the
cutting tool, before carrying
out maintenance and clean-
ing work, before checking
whether the electric cable is
entwined or damaged, or
before leaving the machine
unattended, switch off the
motor and disconnect the
plug.
Danger of electric shock!
Keep the electric cable
away from the cutting tool.
Switch on the motor.
6. Preparing the machine for
operation
Risk of injury
Observe the safety instructions in
the section "For your safety". (
Ö 4.)