Stihl RM 4 R, Instruction Manual

Page: 42 / 400

0478 111 9935 B - EN
40
● Hold upper handlebar (1) on lower
handlebar (2) and insert screws (F)
through bores (3) from the outside
inwards. Fit retaining washers (G) and
lock nuts (H) and tighten.
Tightening torque:
22 - 28 Nm
● Check correct assembly:
The upper handlebar must be firmly
fastened to the lower handlebar.
7.4 Installing the cable clips
● Press cable clips (B) onto the
upper handlebar as described
below. Insert the cables into cable
clip (B) as shown, close tab (4) and
allow it to engage.
● RM 4 R:
Fasten motorstop cable (1) to the left
upper handlebar using cable clip (B).
● RM 4 RT:
Fasten motorstop cable (1) to the left
upper handlebar using cable clip (B).
Fasten self-propulsion cable (2) to the
right upper handlebar using cable
clip (B).
● RM 4 RV:
Fasten motorstop cable (1) to the left
upper handlebar using cable clip (B).
Fasten self-propulsion cable (2) and
Vario drive cable (3) to the right upper
handlebar using cable clip (B).
● RM 4 RTP:
Fasten motorstop cable (1) and self-
propulsion cable (2) to the right upper
handlebar using cable clip (B).
Fasten motorstop cable (1) to the
centre of the rear carrying handle using
cable clip (B).
Observe distance A between the lower
edge of the boot/panel and the cable clip.
RM 4 R, RM 4 RT, RM 4 RV:
A = 42 - 44 cm
RM 4 RTP:
A = 37 - 39 cm
7.5 Attaching the self-propulsion
cable
● RM 4 RT, RM 4 RTP:
Press self-propulsion cable (1) into
guide (2) on the detent segment.
● RM 4 RV:
Insert Vario drive cable (3) into
guide (2) on the detent segment, press
self-propulsion cable (1) into the guide
over this cable.
7.6 Fuel and engine oil
Fuel
Only use fresh, good quality fuel:
– Environmentally friendly,
unleaded petrol
Please consult the engine
instruction manual for precise details on
the fuel quality (octane rating) and on
using special, environmentally friendly
fuels.
Engine oil
Only use the following
biodegradable engine oils:
– STIHL SAE 30
– STIHL 10W-30
Please consult the engine instruction
manual for the oil capacity.
Filling the fuel tank
Always use a suitably dimensioned
funnel when filling the tank with fuel,
in order to prevent the fuel from spilling.
● Unscrew tank cap (1).
● Insert funnel (2).
● Hold canister (3) steadily and pour in
the fuel carefully in several stages only
as far as the lower edge of the filler neck
so that the fuel has room to expand.
The more fuel has already been filled
into the tank, the smaller the filling
quantities should be for each filling
operation.
Keep checking the filling level of the
tank at regular intervals while filling the
tank; remove the funnel for this
purpose.
● Screw tank cap (1) back on again.
8. 1 General
● Place the machine on level and firm
ground when performing all the
operations described.
5
6
7
Check the oil filling level at regular
intervals (see engine instruction
manual).
Note
The fuel system of the STIHL lawn
mower is designed so that
evaporative emissions are
minimised.
8. Controls
Risk of injury!
Observe the safety instructions in
the section "For your safety" (
Ö 4.).
8