Stihl Msa 200 c, Instruction Manual

Page: 71 / 352

MSA 200 C
English
69
Filler cap is locked
If the filler cap will not lock onto the oil
tank
The base of the filler cap is tilted in
relation to the upper part.
N
Remove the filler cap from the oil
tank and look at it from above
N
Fit filler cap and twist it
counterclockwise until it engages in
the seat of the filling port
N
Continue to twist the filler cap
counterclockwise (approx. 1/4 turn)
– this will twist the base of the cap
into the correct position
N
Twist the filler cap clockwise and
close it – see section "Closing"
The saw chain must always throw off a
small amount of oil.
NOTICE
Never operate your saw without chain
lubrication. If the chain runs dry, the
whole cutting attachment will be
irretrievably damaged within a very short
time. Always check chain lubrication and
the oil level in the tank before starting
work.
Every new chain has to be broken in for
about 2 to 3 minutes.
After breaking in the chain, check chain
tension and adjust if necessary – see
"Checking Chain Tension".
Left: Base of filler cap is tilted –
interior marking (1) is aligned
with the exterior marking
Right: Base of filler cap is in the cor -
rect position – interior
marking is below the clip. It
does not align with the exte
-
rior marking
001BA241 KN
1
001BA238 KN
001BA239 KN
Checking Chain Lubrication
143BA024 KN