MS 193 C
English
26
Positions of Choke Shutter
Choke shutter closed
l
– for starting
the engine
Select this position:
–
if the engine is cold
–
if the engine stalls when you open
the throttle after starting.
–
if the fuel tank was run until empty
(engine stopped).
Choke shutter open
j
– for starting the
engine
Select this position:
–
if the engine is warm, i.e. if it has
been running for about one minute.
–
When the engine begins to fire
–
after clearing a flooded combustion
chamber.
Setting the Master Control Lever
To move the Master Control lever from
the normal run position (
F
) to starting
throttle (
n
), press down the throttle
trigger lockout and squeeze the throttle
trigger at the same time and hold them in
that position – now set the Master
Control lever.
The Master Control lever moves from
the starting throttle position (
n
) to the
run position (
F
) when you press down
the throttle trigger lockout and blip the
throttle trigger at the same time.
To switch off the engine, move the
Master Control lever to Stop (0).
Manual fuel pump
The manual fuel pump bulb must be
pressed:
–
When starting for the first time.
–
if the fuel tank was run until empty
(engine stopped).
Holding the Saw
There are two ways of holding the saw
when starting.
On the ground
N
Place your saw on the ground.
Make sure you have a firm footing –
check that the chain is not touching
any object or the ground.
N
Hold the saw firmly on the ground
with your left hand on the front
handle – your thumb should be
under the handle.
N
Put your right foot into the rear
handle and press down.
Starting / Stopping the
Engine
418BA016 KN
418BA005 KN
