HT-KM
English
10
N
Push the lug (1) on the drive tube
into the slot (2) in the coupling
sleeve as far as stop.
When correctly installed, the red line (3)
(arrow point) must be flush with the end
of the coupling sleeve.
N
Tighten down the star knob (4)
firmly.
Removing the KombiTool
N
Reverse the above sequence to
remove the drive tube.
A cutting attachment consists of the saw
chain, guide bar and chain sprocket.
The cutting attachment that comes
standard is designed to exactly match
the pole pruner.
–
The pitch (t) of the saw chain (1),
chain sprocket and the nose
sprocket of the Rollomatic guide bar
must match.
–
The drive link gauge (2) of the saw
chain (1) must match the groove
width of the guide bar (3).
If non-matching components are used,
the cutting attachment may be damaged
beyond repair after a short period of
operation.
Chain Scabbard
The scope of supply includes a bar
scabbard that matches the cutting
attachment.
If guide bars of different lengths are
mounted to the pole pruner, always use
a chain scabbard of the correct length
which covers the complete guide bar.
The length of the matching guide bars is
marked on the side of the chain
scabbard.
Mounting the KombiTool
1
002BA326 KN
2
3
002BA327 KN
4
Cutting Attachment
001BA248 KN
1
2
3
a
001BA244 KN
Summary of Contents for KombiTool HT-KM 4182
Page 1: ...STIHL HT KM Instruction Manual...
Page 2: ......
Page 31: ......
Page 32: ...www stihl com 04584730121C 0458 473 0121 C 0458 473 0121 C englisch G...