HL 94
English
23
NOTICE
Replace any damaged parts!
N
Insert felt filter (5) form-fittingly into
the filter housing
N
Set knob for warm start (1) to
g
N
Fit filter cover (3) – make sure not to
tilt the screw (2) – insert screw and
tighten
Exhaust emissions are controlled by the
design of the fundamental engine
parameters and components (e.g.
carburation, ignition, timing and valve or
port timing) without the addition of any
major hardware.
The carburetor has been set at the
factory to provide an optimum fuel-air
mixture under most operating
conditions.
Adjusting Idle Speed
Engine stops while idling
N
Turn the idle speed screw (LA)
slowly clockwise until the engine
runs smoothly.
Cutting blades run when engine is idling
N
Turn the idle speed screw (LA)
slowly counterclockwise until the
cutting blades stop running.
WARNING
If the cutting blades continue moving
when the engine is idling, have your
power tool checked and repaired by your
servicing dealer.
Engine Management
Adjusting the Carburetor
0208BA036 KN
Summary of Contents for HL 94
Page 2: ...Instruction Manual 1 39 Manual de instrucciones 40 82 ...
Page 85: ...HL 94 español EE UU 83 ...
Page 86: ...HL 94 español EE UU 84 ...
Page 87: ......