FSA 90 R
English
23
Storing the Battery
N
Take the battery out of the power
tool or the charger.
N
Store indoors in a dry and safe
location. Keep out of the reach of
children and other unauthorized
persons and protected from
contamination.
N
Do not store spare batteries unused
– use in rotation.
To optimize the life of the battery, store
it at a state of charge of about 30%.
Storing the Charger
N
Remove the battery.
N
Disconnect the plug from the wall
outlet.
N
Store the charger indoors in a dry
and secure location. Keep out of the
reach of children and other
unauthorized persons and
protected from contamination.
Placing Power Tool on the Ground
N
Move the retaining latch to
ƒ
and
remove the battery.
N
Position your power tool so that the
cutting attachment mounting face is
pointing up.
Replacing Nylon Line
Always check the mowing head for signs
of wear before replacing the nylon line.
WARNING
If there are signs of serious wear,
replace the complete mowing head.
The nylon mowing line is referred to as
"nylon line" or "line" in the following.
The mowing head is supplied with
illustrated instructions for replacing the
nylon line. Keep the instructions for the
mowing head in a safe place.
N
If necessary, remove the mowing
head.
Adjusting Nylon Line
STIHL SuperCut
Fresh line is advanced automatically if
the remaining line is at least 6 cm
(2 1/2 in) long. The blade on the
deflector trims overlong lines to the
correct length.
STIHL AutoCut
N
With the engine running, hold the
rotating mowing head above the
grass surface.
N
Tap it on the ground once – fresh
line is advanced and the blade on
the deflector trims it to the right
length.
Fresh line is advanced every time the
mowing head is tapped on the ground.
For this reason observe the mowing
head's cutting performance during
operation. If the mowing head is tapped
on the ground too often, the line limiter
blade will unnecessarily cut off unused
lengths of nylon line.
Line feed operates only if both lines are
still at least 2.5 cm (1 in) long.
Replacing Nylon Line
STIHL PolyCut
Precut lengths of nylon line can be fitted
to the PolyCut in place of the cutting
blades.
Maintaining the Mowing
Head
3988BA028 KN
