Stihl FS 40, Service Manual

Page: 74 / 82

73 Series 4144 Components FC, FS, KM
The engine end of the drive tube
has cross holes, this end is installed
in the machine.
– Line up the loop handle (1) so
that the star knob screw (arrow)
points towards the engine.
:
Slide the loop handle (1) onto the
engine end of the drive tube.
– Install the drive tube,
b
9.1
:
Position the loop handle (1) at a
distance of
about 7 cm (a) in front of the
engine housing.
– Line up the loop handle (1) so
that it points away from the
throttle trigger.
– Tighten down the star knob
screw (2) firmly.
1
545RA260 TG
a
1 2
545RA261 TG
9.1.7 Loop Handle with
Barrier Bar
– Remove the drive tube,
b
9.1
:
Loosen the screw (1).
– Slip the loop handle (2) off the
drive tube.
– Take out the screw.
:
Pull the clamp (1) out of the loop
handle (2).
1
2
545RA262 TG
2
545RA263 TG
1
– Take out the screw (arrow) and
washer.
:
Remove the barrier bar (1).
– Check the individual parts and
replace if necessary.
– Reassemble in the reverse
sequence.
:
Push the clamp (1) into the loop
handle (2).
– Insert the screw (1)
– do not tighten it down yet.
1
545RA264 TG
545RA287 TG
1
2