FS 111 RX
English
21
The type and style of the
harness/shoulder strap depend on the
market.
The use of the harness is described in
the chapter on "Approved Combinations
of Cutting Attachment, Deflector, Handle
and Harness".
Shoulder Strap
N
Put on the shoulder strap (1).
N
Adjust the length of the strap so that
the carabiner (2) is level with your
right hip when the machine is
attached.
N
Balancing the Machine
Attaching Machine to Harness
The type and style of the harness or
shoulder strap and carabiner depend on
the market.
N
Attach the carabiner (1) to the
carrying ring (2) on the drive tube.
N
Loosen the screw (3).
Balancing the Machine
N
Adjust the carrying ring.
N
Tighten the screw moderately.
N
Let go of the brushcutter and check
to see how it is balance – the cutting
attachment should just touch the
ground in the normal working
position.
N
Move the carrying ring as required.
When the correct balanced position has
been reached:
N
Tighten down the screw on the
carrying ring firmly.
Disconnecting Machine from Harness
N
Press down the bar on the
carabiner (1) and pull the carrying
ring (2) out of the carabiner.
Fitting the Harness
1
2
0000-GXX-1555-A0
Balancing the Machine
1
2
1
2
0000-GXX 1056-A0
0000-GXX-1321-A0
3
0000-GXX-1289-A0
1
1
0000-GXX-1290-A0
2
2
