15
FC 83
english / USA
:
Place the power edger on a
suitable support so that the blade
mounting (
1
) faces upwards.
:
Insert the Allen wrench (
2
) as far as
possible in the bore (
3
) – push
lightly and rotate it back and forth
together
with the thrust washer (
4
)
until the drive shaft is blocked.
:
Apply combination wrench
(5)
to
screw
(6)
.
:
Loosen screw clockwise (left-hand
thread) and take it out.
:
Remove retaining ring, plain washer
and thrust washer.
:
Position blade
(7)
on the thrust
plate
(8)
.
Collar
(see arrow)
must engage
hole in blade!
:
Fit thrust washer
(4)
on the drive
shaft
(9)
.
:
Block the drive shaft.
:
Insert screw
(12)
with plain washer
(10)
and retaining ring
(11)
in shaft
counterclockwise and tighten down
firmly.
Fitting the Cutting Blade
1
245BA010 KN
6
3
245BA011 KN
2
4
5
8
4
7
245BA012 KN
9
10
11
12
7