BF-KM
English
11
Mounting the Gearbox
N
Loosen the clamp screws (4).
N
Push the gearbox (5) onto the drive
tube (2) – turn the gearbox back and
forth as necessary until the housing
is approximately in line with the
mark.
Aligning the Drive Tube
N
Line up the gearbox on the drive
tube so that the deflector (1) and the
rotor blades (6) are vertical and the
fixing lug (arrow) on the drive
tube (2) points up.
N
Tighten down the clamp screws
firmly.
NOTICE
It must not be possible to rotate the
gearbox on the drive tube.
Mounting the Rotor Blades
Take care not to lose the two washers
on the gearbox output shaft.
N
Arrange the blades in the order they
will be fitted on the shaft, noting the
following points:
Left-hand and right-hand blades are
different. The direction of rotation is
marked with arrows on the gearbox and
blades.
N
Rotate the inner right-hand
blade (7) on the shaft until it can be
pushed into position – check the
direction of rotation again (arrows).
The hub of the inner blade is larger than
that of the outer blade.
N
Rotate the outer right-hand
blade (8) on the shaft until it can be
pushed into position – check the
direction of rotation again (arrows).
N
Insert and engage the hitch pin (9)
in the hole in the shaft – fold the
hitch pin flat against the blade.
N
Use the same procedure to mount
the rotor blades on the left-hand
side.
N
Push the lug (1) on the drive tube
into the slot (2) in the coupling
sleeve as far as stop.
When correctly installed, the red line (3)
(arrow point) must be flush with the end
of the coupling sleeve.
N
Tighten down the star knob (4)
firmly.
Removing the KombiTool
N
Reverse the above sequence to
remove the drive tube.
Mounting the KombiTool
1
002BA326 KN
2
3
002BA327 KN
4
