0458-726-9821-C
47
English
6 Assembling the Trimmer
► If 3 LEDs on the battery flash red while you are checking
the controls: Pull connecting cable plug out of the
socket and contact your STIHL dealer for assistance.
There is a malfunction in the trimmer.
► If you cannot carry out these steps: Do not use your
trimmer and contact your STIHL dealer for assistance.
6.1 Mounting the Bike Handle
► Switch off the trimmer and pull the connecting cable plug
out of the socket.
► Remove the wingscrew (1).
► Remove the upper clamp molding (2).
► Place the handlebar (3) in the lower clamp molding (4).
► Fit the upper clamp molding (2).
► Insert the wingscrew (1).
► Swing the handlebar (3) up.
► Tighten down the wingscrew (1).
► Take out the screw (6).
► Position the control handle (7) on the handlebar (3),
trigger facing the gearhead, and line up the hole in the
control handle with the hole in the handlebar.
► Fit the nut (7).
► Insert and tighten down the screw (6).
The loop handle (2) need not be removed again.
6.2 Mounting and Removing the Deflector
6.2.1 Mounting the Deflector
► Switch off the trimmer and pull the connecting cable plug
out of the socket.
► Push the deflector (1) into the guides on the gear housing
as far as stop.
► Insert and tighten down the screws (2) firmly.
6.2.2 Removing the Deflector
► Switch off the trimmer and pull the connecting cable plug
out of the socket.
► Take out the screws (2).
► Pull off the deflector (1).
6 Assembling the Trimmer
0000-GXX-3026-A0
1
2
3
4
6
7
8
3
1
2
0000-GXX-3027-A0
0000-GXX-3029-A0
1
2
