WORKSHOP MANUAL
ZT 5132 T
Chapter
6 - CUTTING DECK
EDITION
2017
PAGE
37 /
58
NOTE
-
The entire support element (3), including
shafts and bearings, is a spare part available as
single assembly unit, including the pulley.
Reassemble all removed parts following the
above instructions in the reverse order, making
sure to tighten the four screws (1) with a torque
of 36-40 Nm using a power screwdriver and a
torque wrench.
6.4 REMOVAL OF THE CUTTING DECK
6.4.1 General information
By removing the cutting deck you can carry out all servicing and replacement operations on the
blade flanged supports and the drive systems more comfortably and easily.
With some practice and experience it is possible to do this job with the deck still in position.
6.4.2 Removal and reassembly of the cutting deck
1. Place blocks under the edge of the deck edge and lower the deck so that you can lean on it,
without the risk of falling during removal.
2. Remove the left cover (1) fixed by three screws (2).
3. Remove the centre cover (3) fixed by four screws (4).
1
2
2
3
4
3