Stiga MP1 500 Li D48 Series, Operator'S Manual

Page: 73 / 222

EN - 7
To remove the chute plug:
1. Lift the rear discharge guard (Fig.14.A).
2. Press on the centre to release the claw (Fig.14.D).
6.1.3 Cutting height adjustment
Adjust the cutting height as indicated in par. 5.6.
6.2 SAFETY CHECKS
Perform the following safety checks and check that the
results correspond to those outlined on the tables.
Always carry out the safety checks before use.
6.2.1 General safety check
Object Result
Grips Clean, dry.
Handle Fixed firmly to the machine.
Cutting means Clean, not damaged
or worn.
Rear discharge guard;
grass catcher
Good condition. No
damage. Properly installed.
Side discharge guard;
side discharge chute
Good condition. No
damage. Properly installed.
Switch command
Operator presence lever
Drive ON lever
The lever must move
freely, it must not need
forcing and should
return automatically
and rapidly back to
the neutral position.
Battery No damage to the casing,
no liquid leakage.
Screws/nuts on the
machine and on the
cutting means
Correctly tightened
(not loose).
Cooling air ducts Not clogged.
Machine No signs of damage
or wear.
6.2.2 Machine operating test
Action Result
1. Start the machine
(par. 6.3).
2. Enable the cutting
means (par.6.3 ).
3. Release both op -
erator presence
levers (Fig.21.A).
1. The display turns
off and the machine
is ready for use.
2. The cutting means
should move.
3. The levers should
return automatically
and rapidly to the
neutral position, the
motor must switch
off and the cutting
means must stop
within a few seconds.
1. Start the machine
(par. 6.3).
2. Operate the drive
lever (para 5.4).
3. Disengage the
drive lever.
1. The display turns
off and the machine
is ready for use.
2. The wheels should
move the ma -
chine forward.
3. The wheels should
stop and the machine
stops moving forward.
Test driving No abnormal vibrations.
No abnormal sound.
If any of the results fail to match the indications
provided in the tables, do not use the machine! Contact
an Authorised Service Centre to have it checked and
repaired if necessary.
6.3 START-UP
NOTE Start up the machine on a flat
surface without obstacles or high grass.
NOTE Check if the battery combination is
correct, following the instructions supplied
in the "Technical data" table.
1. Open the hatch for accessing the bat -
tery compartment (Fig.16.A).
2. Insert the batteries correctly in
their housing (par. 7.2.3).
3. Insert the safety key (Fig.17.B) com -
pletely and turn it to "ON" position.
4. Press the start button (Fig.18.A) The dis -
play remains switched on for 15 sec.
5. Engage the cutting means by first pressing the
safety button on the right side (Fig.19.A) and then
pressing the operator presence lever (Fig.19.B).
6. To engage the traction, press the le -
ver behind the handle (Fig.19.C).