Stiga 13-7454-11, Workshop Manual

Page: 28 / 123

2.4 Cab
2.4.1 Changing the windows
Remove the different windows as follows:
Replacing the side window A
1. Unscrew the screws A (5x) and lift out
the window.
2. Install a new seal strip on the new side
window.
When you install the new window ensure
that you position the plates, rubber gas-
kets and washers in the same place as
the previous window. See image.
Changing door window
1. Remove the door cylinder from the
door frame.
2. Remove the whole door by unscrew-
ing the screws B (2x).
3. Remove the door handle, unscrew the
screws C (2x), D (2x), E.
4. Unscrew the remaining screws F (2x)
and lift out the window.
5. Install a new seal strip on the new side
window.
Reassemble in reverse order.
Make sure that the plates, rubber gas-
kets, washers and seal at the handle are
in the same place as in the previous win-
dow. See image.
F
B
F
E
WORKSHOP MANUAL
TITAN
Chapter
2 - Chassis and bodywork
EDITION
2018
Page
2 6