OPeRATION
Safety
TWS, TWG
| 17
ENGL
IS
H
1.3 Other symbols in this documentation
Note
General information is identified by the adjacent sym-
bol.
f
f
Read these texts carefully.
Symbol
Material losses
(appliance damage, consequential losses and environ-
mental pollution)
Appliance disposal
f
f
This symbol indicates that you have to do something. The
action you need to take is described step by step.
1.4 Information on the appliance
f
f
Always observe the information on the appliance and
keep it legible.
1.5 Units of measurement
Note
All measurements are given in mm unless stated oth-
erwise.
2. Safety
2.1 Intended use
The appliance is designed for decentralised dHW heating.
The appliance is intended for domestic use. It can be used safe-
ly by untrained persons. The appliance can also be used in
non-domestic environments, e.g. in small businesses, as long
as it is used in the same way.
Any other use beyond that described shall be deemed inappro-
priate. Observation of these instructions and of the instructions
for any accessories used is also part of the correct use of this
appliance.
TWG
The stainless steel soldered heat exchanger is particularly suit-
able for applications where water quality is critical.
2.2 Safety instructions
!
WARNING Injury
The appliance may be used by children over 8 years
of age and persons with reduced physical, sensory
or mental capabilities or a lack of experience and
expertise, provided that they are supervised or they
have been instructed on how to use the appliance
safely and have understood the potential risks. Chil-
dren must never play with the appliance. Children
must never clean the appliance or perform user
maintenance unless they are supervised.
WARNING Burns
-
Hot water or steam may escape.
-
Pipework and parts of the appliance may be-
come hot.
!
Material losses
In the event of water damage, immediately shut down
the appliance.
!
Material losses
The user should protect the system against moisture
and frost.
!
Material losses
There is a risk of fire.
f
f
do not store any combustible materials near the
appliance.
Note
do not cover the air slots in the casing door.
f
f
ensure adequate air circulation.
3. Appliance description
The appliance provides the required amount of dHW at the
preferred temperature at the draw-off points. This occurs with-
in the output limits of the appliance.
!
