iNSTAllATiON
Preparation
16
| SHP-A 220-300 Plus
www.stiebel-eltron.com
Note
For details on sounds emissions, see chapter "Specifica-
tion / Data table".
9.4 Siting the appliance
Note
Accessories are located in the corners of the packaging.
Remove the accessories before disposing of the pack-
aging.
f
f
Carefully undo the cardboard packaging at the clips.
D
00000
34
79
7
1
1 Cardboard packaging clips
The appliance is secured to the pallet with metal brackets and
screws. The metal brackets are hooked on to the feet underneath
the floor plate of the appliance.
2.
1.
D
00000
34
79
8
1
1 Metal bracket fixing screw
f
f
Remove the fixing screws of the metal brackets from the
pallet.
f
f
Push the metal brackets a little towards the cylinder centre to
unhook them from the appliance feet.
f
f
Pull the metal brackets out from underneath the appliance.
!
Material losses
Take note of the appliance's weight and centre of gravity.
f
f
Slightly tip the appliance and carefully roll the appliance off
the pallet.
f
f
Position the appliance in the final installation site.
Minimum clearances
≥150
≥350
≥400
≥400
≥500
D
00000
20
78
3
f
f
Maintain the minimum clearances.
!
Material losses
The appliance must be positioned vertically to avoid
damage.
The feet under the floor plate of the appliance are
height-adjustable.
f
f
Level the appliance horizontally using the height-ad-
justable feet.
D
00000
34
80
6
