Stewart Filmscreen
– Cabaret
17
IR RECEIVER AND REMOTE (STANDARD)
_____________
A 3-button IR (infrared) remote control
(see Figure 17) is supplied for the standard control system
IMC (see Figure 18). The IMC control board comes ready to be operated via IR and projector
trigger right out of the box. You may visit StewartFilmscreen.com for a full list of IR Hex codes if you
want to program the IR to another remote.
GETTING STARTED
Making the Connections
If an IR receiver is optioned at the time of purchase,
then the receiver will be pre-installed at the factory.
No further connections need to be made by the
customer or installer. Simply plug in the power and
use the supplied 3 button remote to operate the
screen.
Note:
Cabaret may come with one RJ25 male
output (if equipped). The maximum length of the
RJ25 cable plugged into the unit shall not exceed
50’.
Dry closure modules from any home automation
system can be interfaced, utilizing
up/down/common type terminations
only
on the
dry contact/trigger cable (see Figure 19).
Power cord
Figure 19:
Rear, audience left of case with
10 ft. power cord, RJ25 output (if equipped)
and a dry contact/trigger wire
Dry contact/trigger
RJ25 accessory
plug (if equipped)
Figure 17:
IR remote and receiver
Figure 18:
IMC control system
