FLX-E Operations Manual Rev F
Page 3
Table of Contents
Top
3.3.4
Speaker Damage
Loudspeakers may be damaged or destroyed if overpowered. Always check the loudspeaker’s continuous
and peak power ratings to prevent such an occurrence. Do not rely solely on the amplifier’s volume control
to reduce output power to a level safe for the loudspeakers. Stewart Audio strongly suggests you use the
limiter block in the DSP chain to limit power to the loudspeakers.
3.3.5
Maintenance
Clean regularly with a soft cloth to remove dust and debris. Also check that vent holes and slots are not
covered and that there is adequate ventilation for convection cooling. If the amplifier is not rack mounted,
be certain that the feet on the bottom of the device allow air to circulate beneath the amplifier. Do not
place on a cushioned surface like a blanket as this may impede cooling.
