Steris Cmax, Operator'S Manual

Page: 57 / 218

5-8
150830-685 Operator Manual Routine Maintenance
5.7 Replacement Parts
The parts listed in this section are those that would be necessary to
do minor maintenance on the Cmax Surgical Table.
To order replacement parts, proceed as follows:
1. Include part number and description listed in Table 5-3 .
2. Include model and serial numbers of your equipment on your
order.
3. Send your order directly to STERIS.
NOTE: NOTE: For Replacement Parts, note the following:
1) Use only STERIS authorized parts on the equipment. Use of
unauthorized parts will void the warranty.
2) This table uses lead-acid batteries. Lead-acid batteries
normally are subject to self-discharge and battery-life
deterioration in long-term storage. Therefore, STERIS does not
recommend that batteries be procured and then stored as
Verify condition of batteries and battery charger status. 1 x per year
Verify Auto Limit Sensor status. 1 x per year
6.0 TABLETOP OPERATION
Check operation of Level function. 1 x per year
Check operation of back section. 1 x per year
Check operation of leg section. 1 x per year
Check lateral tilt operation. 1 x per year
Check Trendelenburg, then Reverse Trendelenburg operation. 1 x per year
Check raise and lower operation. 1 x per year
Check headrest Section operation. 1 x per year
Check SLIDE function. Inspect sliding chain tension.
Check rack and pinion gear play.
1 x per year
7.0 TABLE RIGIDITY
Verify head and leg sections locking devices. 1 x per year
Check for any play in floor-lock legs. 1 x per year
8.0 FINAL TEST
Examine all lubricated parts. Apply lubrication as needed. 1 x per year
Secure all covers and shrouds. 1 x per year
Reinstall any pads that were removed. Check for rips, tears, etc. 1 x per year
Inspect area to ensure removal of all materials used during inspection. 1 x per year
Table 5-2. Preventive Maintenance Schedule for Cmax Surgical Table (Cont’d)
Service Required Minimum Frequency