Steris Basil 4700, Maintenance Manual

Page: 58 / 265

6-6
920509-645 Operator Manual Routine Maintenance
6.3 Weekly Cleaning
Procedures
6.3.1 Clean Washer Exterior
Clean washer exterior with a general purpose cleaner to remove
general stains, a stainless-steel stain remover for stubborn stains,
and a stainless-steel polish to keep equipment looking new.
1. Using a damp cloth or sponge, apply cleaner in a back-and-forth
motion, in same direction as surface grain.
2. Thoroughly wipe off cleaner.
3. Polish surface with a clean, dry and lint-free cloth.
4. Clean door windows, with a general window cleaning product.
5. Dry window with a lint-free cloth.
6.3.2 Clean Washer Interior
After last cycle of day, allow unit to cool, turn LOCK/UNLOCK/INIT
key switch to
LOCK position. Remove key from selector and keep it
on yourself; wearing appropriate Personal Protective Equipment
(PPE), enter wash chamber and proceed as follows:
1. Wash chamber with a mild detergent solution.
2. Rinse with tap water and dry with a lint-free cloth.
3. If interior is stained, use a general purpose cleaner to remove
general stains or a stainless-steel remover for stubborn stains, as
follows:
a. Using a damp cloth or sponge, apply cleaner in a back-and-
forth motion, in same direction as surface grain.
b. Thoroughly wipe off cleaner.
c. Polish surface with a clean, dry, lint-free cloth.
d. Clean door windows with a general window cleaning
product.
e. Dry window with a lint-free cloth.
WARNING – ELECTRIC SHOCK
HAZARD: Disconnect all utili-
ties to washer before servic-
ing. Do not service washer
unless all utilities have been
properly locked out. Always
follow local occupational
health and safety regulations,
as well as electric and plumb-
ing codes.
CAUTION – POSSIBLE EQUIP-
MENT DAMAGE: Use nonabra-
sive cleaners when cleaning
unit. Follow directions on
containers and rub in a back-
and-forth motion (in same
direction as surface grain).
Abrasive cleaners will dam-
age stainless steel. Cleaners
rubbed in a circular motion
applied with a wire brush or
steel wool will scratch and
dull stainless steel. Do not
use these cleaners on painted
surfaces.
WARNING – BURN HAZARD:
Never perform cleaning of
wash chamber until full cycle
has been completed. If cycle
has not been completed con-
taminated debris or water may
remain in the bottom of the
wash chamber.