Steris Basil 1100, Operator'S Manual

Page: 32 / 48

5-4
122996-004 Operator Manual Routine Maintenance
11. Using a damp cloth or sponge, apply cleaner on sump panels in a back
and-forth motion.
12. Thoroughly wipe off cleaner.
After cleaning conveyor rollers, it is necessary to reassemble rollers as follows:
1. Insert roller on roller shaft (pulling inward towards you).
2. Push roller assembly on conveyor shaft, white collar included.
3. Turn white collar until it locks in position over shaft.
4. Reinsert roller spacers.
5. Repeat Steps 1 trough 4 for each roller to be reinstalled.
1. Clean Filler Header manifold, sump and rollers as previously described.
2. Clean Basil ® 1100 Feeder Bottle Filler exterior using Amscrub for general
stains and Pry Stain Remover Cream for stubborn stains.
3. Using a damp cloth or sponge, apply cleaner in a back-and-forth motion, in
same direction as surface grain.
4. Thoroughly wipe off cleaner.
5. Polish surface with a clean, dry, lint-free cloth.
5.3.2 Weekly Cleaning
CAUTION – POSSIBLE
EQUIPMENT DAMAGE:
Use non -abrasive cleaners
when cleaning unit. Follow
directions on containers
and rub in a back-and-forth
motion (in same direction
as surface grain). Abrasive
cleaners will damage stain-
less steel. Cleaners rubbed
in a circular motion or ap-
plied with a wire brush or
steel wool can be harmful
to stainless steel. DO not
use these cleaners on
painted surfaces.