Steris Amsco 3085 SP, Maintenance Manual

Page: 52 / 228

8-2
150830-353 Operator Manual Service Procedures
Two replaceable fuses (F1 and F2) are located in a cartridge above the ac input
in the table base. If one or both of the fuses are blown by a fault condition,
replace as follows:
1. Disconnect ac power cord from wall receptacle and table base input (see
Figure 8-2).
2. Pry cartridge out with a small screwdriver to access fuses.
3. Remove blown fuse(s) and replace. Refer to Table 8-1 for correct rating and
part number of fuses.
4. Push cartridge back into connected position and reconnect ac power cord to
table. Plug cord into wall receptacle.
8.2 Change Fuses
Fuses F1 and F2
Fuse Cartridge
Remove AC Power Cord
Use Small Screwdriver
Figure 8-2. Fuse Location
8.3 Disconnect the
Motor Battery
One replaceable fuse (F3) is located internal to the table. This requires removal
of the base shroud for access. Replacement of this fuse must be made only by
a fully qualified service technician. Refer to
Table 8-1 for correct rating and part
number of fuse.
CB-2 circuit breaker, in addition to being a protective device, includes an
internal, manually operated ON/OFF switch. If necessary, the motor battery can
be disconnected from the table circuit as follows:
For Models manufactured pre mid-2009: For Models manufactured pre mid-2009: For Models manufactured pre mid-2009: For Models manufactured pre mid-2009: For Models manufactured pre mid-2009:
1. Press in on protective boot covering CB-2 circuit breaker until a “click” is felt.
2. Release button.
3. In OFF position, button is popped out same as when circuit breaker is
tripped. To reset, see S
ECTION
8.1, R
ESET
C
IRCUIT
B
REAKERS
.