WARRANTY
This Steren product is warranted under normal usage against defects in
workmanship and materials to the original purchaser for one year from the
date of purchase.
CONDITIONS
1.- This warranty card with all the required information, invoice or purchase
ticket, product box or package, and product, must be presented when
warranty service is required.
2.- If the product stills on the warranty time, the company will repair it free
of charge.
3.- The repairing time will not exceed 30 natural days, from the day the
claim was received.
4.- Steren sell parts, components, consumables and accessories to
customer, as well as warranty service, at any of the addresses mentioned
later.
THIS WARRANTY IS VOID IN THE NEXT CASES:
If the product has been damaged by an accident, acts of God, mishandling,
leaky batteries, failure to follow enclosed instructions, improper repair by
unauthorized personnel, improper safe keeping, among others.
a) The consumer can also claim the warranty service in the purchase
establishment.
b) If you lose the warranty card, we can reissue it, if you show the invoice
or purchase ticket.
RETAILER INFORMATION
Name of the retailer
Address
Product
Brand
Part number
Serial number
Date of delivery
In case your product fails or have questions, please contact your
nearest dealer. If you are in Mexico, please give a call to our Call
Center.
Call Center
01 800 500 9000
Before using your new Electronic insect killer, please read
this instruction manual to prevent any damage. Put it away in
Before using your new Steren Passive crossover network,
please read this instruction manual to prevent any damage.
Put it away in a safe place for future references.
Before using your new Electronic insect killer, please read this
instruction manual to prevent any damage. Put it away in a
Product design and specifications are subject to change
without previous notice.
Product: Passive crossover network
Part number: CR2-800 / CR3-1000
Brand: Steren
Your new device allows one to separate the different parts of the frequency
spectrum and sends it to the right speakers.
Model CR2-800 is a two-way passive crossover (low frequencies and
high frequencies). Model CR3-1000 is a three-way passive crossover (low
frequencies, medium frequencies and low frequencies).
The Passive Crossover Network is an inductive-capacitive circuit
designed to separate the different parts of the frequency spectrum,
usually used on coaxial speakers (superposed) and multiple speaker
systems. Each one with different characteristics and different sizes.
With this device you can reproduce specific parts of the audio
frequency spectrum.
To start to use the passive crossover, follow these steps:
1.- Locates the input for the amplifier signal and the speakers outputs.
2.- Fix the device to avoid hits or drops.
3.- Put the corresponding cables to the different speakers or monitors,
paying attention about polarity.
4.- Connect the amplifier to the passive crossover.
- Clean with a soft, dry cloth.
- Do not try to open the equipment, may cause malfunction and warranty
will be void.
- Do not use or store the equipment near wet places. May cause
malfunction or shock hazard.
HIGHLIGHTS
INSTRUCTIONS
IMPORTANT
Channels
CR2-800
CR3-1000
1
1
Separation
frequency
4.5 - 7kHz
1
.
4 - 2.8kHz
Ways
2
3
Impedance
4 ohms
4 ohms
Power output
200W
rms
200W
rms
SPECIFICATIONS
