OPERATION
SYSTEM FEATURES
USER GUIDE AND INSTALLATION MANUAL
STERS1050 - REMOTE START ADD-ON
STERS1050
Engine Start + Turbo Timer Module
Owner’s & Installer’s Manual
• Tach or Tachless Start(Alternator)
• Smart RPM Learning Adjustor
• Op/- Glow Plug Input
• Turbo Timer
• Timer Start
• Programmable Engine Running Time
• Programmable Cranking Time
• Bypass Output
• Safety Wire
• Compatible with Auto or Manual Transmission
• Anti-grind
Starting & Stopping the Engine:
a
. Feed Activation Input (PINK) with three negative
pulses within 5 seconds to start or stop the engine
running alternately.
b
. During the turbo timer mode, feeding Activation
Input (PINK) with two negative pulses will stop the
turbo timer, and the timed start will not be started.
c
. During timer start mode, feeding Activation Input
(PINK) with two negative pulses will stop the timer
start, and ignition engine. Timer start will be re-start-
ed until the engine shut down
d
. During a timed start and with the engine running,
feeding Activation Input (PINK) with two negative
pulses will shut down engine and timer start will
re-start.
With the Engine Running, (or in turbo timer mode):
1 Disarm the car alarm
2. Insert the car key into the ignition then switch to
On position.
3. Step on the footbrake or pull down the hand-
brake, then go.
* The engine will shut down if the footbrake is
tapped or handbrake is pulled down before switch-
ing the ignition on.
ByPass Output (RED/BLACK)
This wire is designed for bypassing the external
device when the engine is started by the
RS1050.
a
.Bypass Output (RED/BLACK) will send the
solid negative signal during the engine start or
turbo timer mode.
b
.The solid negative signal will halt when the
engine start or turbo timer mode is stopped.
Glow Plug
(wait-to-start inputs, -GREEN/WHITE or
+PURPLE/WHITE)
These wires are designed for a diesel engine.
Select negative or positive depending on your
needs.
a
.For the car equipped with diesel engine, this
wire must be connected to the wait-to-start light
in the dashboard. Connect negative
(GREEN/WHITE) to the wait-to-start light if the
light is negative trigger or c(PUR-
PLE/WHITE) to the light if positive trigger.
*
For the car equipped with gasoline
engine, connect one of them to the
ground or +12v source.
Safety Wire-Hood Pin(BLUE)
a
.Connect this wire to the hood pin switch. The
switch must provide a ground output when
switch is opened.
b
.The engine will stop running or not be started
when this wire provides a ground output.
Footbrake & Handbrake(BLACK/RED)
Connect Hand or Footbrake (BLACK/RED) to the
Handbrake for the car equipped with manual
transmission or to the footbrake for auto trans-
mission vehicle. Brake must send out 12v signal.
If it is a negative output, you will need to use a
relay to reverse polarity.
1.
